Utility Locator

SOME POWER CABLES DO NOT RADIATE DETECTABLE POWER SIGNALS.

CUSTOMER RESPONSIBLE TO DIG WITH CAUTION, EVEN IF USING UTILITY LOCATOR.

***********************

TO LOCATE BURIED PIPES AND CABLES.

The Genny4 is used to actively apply a locate signal to pipes or cables. This signal can be traced using the C.A.T4 locator in either Avoidance Mode or Genny mode. Use of the Genny is strongly recommended, as passive power or radio signals may not be present, or detectable, on all pipes and cables

C.A.T4 models are equipped with four locate modes:

1. Avoidance Mode: Avoidance mode: detects all locate signals simultaneously,

including Genny, Power, and Radio signals. The sensitivity control adjusts the Power,

Radio and Genny signal levels simultaneously.

2. Genny Mode: detects the locate signals produced by a Genny. There are various ways of applying the Genny signal.

Using a Genny is the most reliable way to detect a pipe or cable. The C.A.T4 and Genny4 feature new locate signals

that make the combination more sensitive to small core cables (e.g. telecoms & street lighting).

3. Power Mode: detects signals originating from power transmission networks.

These signals may be found on any pipe or cable, not just power cables.

4. Radio Mode: detects radio signals originating from distant radio transmitters as they travel along underground pipes and cables.